Predator Infernus

Building a predator Infernus to use as a Baal Predator in my army.

This tank has an unique build pattern where you must attach the roof before attaching the outer side panels.
 

 

There is some slight warping to those panels, so using a blow dryer to warp back to normal or holding it really firmly when gluing it into place is necessary.

 

 

There is a small cast flaw where the casting tails (what ever they are called) are attached. This hole was on both panels so I think that it will be normal on all of these tanks. It's really in a bad place.

 

 

So after cleaning all the parts I assemble the model up to the point of painting.

 

 

I pin the front ram into place. This model has a better connection than the GW tanks, as it runs flush to the main body at more angles, but wanted to be safe and pin it. 

 

 

Ready for paint after putting some damage on it.